Pflege Pro PCB
USAGE:
The tracks on the printed circuit boards (P.C.B.) tend to get easily oxidized due to their very nature. Also the solder quality can deteriorate over time due to atmospheric effects. To avoid this it is an advisable practice to apply a protective coat of Pflege Pro PCB. This is a polymer based film forming formulation, single pack & is quick air drying . The film is impervious to atmospheric oxygen & humidity & hence provides a superlative protection to PCB’PCB’s
PHYSICAL PROPERTIES:
Appearance Liquid
Colour Colorless Transparent
Odour Typical Aromatic
Density 0.80 approx.
Homogeneity Consistent
Dielectric Strength 50KV/mm
APPLICATION:
  • Apply using brush or spray.
  • Allow to air dry. Don’t touch film when it is tacky & allow it to fully dry up. Touch dry time 1 min. approx.
  • No oven baking is required.
HANDLING PRECAUTIONS:
  • Store in cool and dry place with airtight lid.
  • While applying if Pflege Pro CS,  is spilled on skin, just wipe clean when wet. If dried, peel off lightly.
  • If brush or spray gun is used, clean up after use by Pflege Pro CS, SOLVENT.
PACKING:
5 Litter HDPE can / 450 ml aerosol can.
SECTOR WISE USAGE:
Electronic Industry, IT Industry.